raidcom disconnect external_grp
Error message
Executing/
Async
Error code
Description
SSB1 SSB2
CMDRJE Executing 2E10 4100 The specified external volume group is in the state
of disconnected.
CMDRJE Executing 2E10 4102 The specified external device is in the state of
disconnected.
CMDRJE Executing 2E10 4301 The specified external volume has already
disconnected the path, or is in the process of
checking path.
CMDRJE Executing 2E11 0007 It is in the state of shredding.
CMDRJE Executing 2E11 001B The target LDEV is blocked.
CMDRJE Executing 2E11 4000 The path for the specified external path is in the
state of disconnected.
CMDRJE Executing 2E11 410D The DP-VOL with the Data Direct Mapping
attribute which is allocated to the specified
external volume is not blocked.
CMDRJE Executing 2E11 4302 All the paths for the specified external path are
blocked.
CMDRJE Executing 2E11 6005 The specified external volume belongs to a Thin
Image or Copy-on-Write Snapshot where the pair
in the PSUS status exists.
CMDRJE Executing 2E11 800E The operation cannot be performed because the
internal processing is in progress. Wait for a while,
then retry the operation.
CMDRJE Executing 2E20 4100 There is no specified external volume.
CMDRJE Executing 2E20 4300 There is no specified path.
CMDRJE Executing 2E30 000A It is included the Hitachi Dynamic Provisioning
volume that is associated with a pool.
CMDRJE Executing 2E30 000C The specified LDEV is used as a quorum disk.
CMDRJE Executing 2E30 000E It is used as a pool volume.
CMDRJE Executing 2E30 000F It is used as a journal volume.
CMDRJE Executing 2E30 0014 It is used as a reserved volume of Volume
Migration.
CMDRJE Executing 2E30 001A Volume Security is set.
CMDRJE Executing 2E30 001C It is used as a remote command device.
CMDRJE Executing 2E30 001E Online from the mainframe host.
CMDRJE Executing 2E30 004E This is a volume that the Data Retention Utility is
set.
CMDRJE Executing 2E30 0061 The Dynamic Provisioning volume not in the
blocked state is included in the Dynamic
Troubleshooting
9-33
Command Control Interface User and Reference Guide
To Next Page
Loading...
