EasyManua.ls Logo

HITWAY BK19 - Battery Maintenance; Legal Requirements; Riding

HITWAY BK19
261 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
To avoid shortening the lifetime of the battery, please follow the steps below:
· Charge the battery after riding when the charge is between 30 % and 40 %.
· Make sure that the battery is not completely discharged.
· Fully charge the battery before storing it for an long period of time.
· Store the battery in a dry place with low levels of humidity.
· Keep the temperature between 5 °C and 20 °C.
· Do not expose the battery to direct sunlight or high temperatures, e.g. in a warehouse.
· Make sure that stored batteries are charged at least once a month. Make sure that stored batteries are fully
charged at least once every 3 months.
Battery Maintenance
Moisture, dust or mechanical damage can cause a short circuit. This may cause the battery to catch fire or
explode.
· Clean the outside of the motor and control unit only with a moistened cloth.
· If parts are accidentally completely immersed in water, disconnect the motor from the batteries immediately
and re-commence operation after inspection by the manufacturer.
· Follow the relevant manufacturer's instructions.
Motor and Control Maintenance
Batteries in particular should be stored in a temperature-controlled, dry environment.
Read all manuals for the components and be careful before using chemicals, paints or cleaning products on
the bike's electrical components.
If you want to ride your e-bike on public roads, you must equip it in accordance with national regulations.
Legally, our 25 km/h models are treated in the same way as bicycles and are therefore subject to the same
regulations. In Germany, these issues are regulated by the Road Traffic Permit Ordinance (StVZO) and the
Road Traffic Ordinance (StVO).
Legal Requirements
Do not use it until you have carefully read the instructions and understood the performance of the product;
do not lend it to anyone who cannot manipulate the product for riding. Before riding the bike, check that the
brakes are working. When braking, please activate the rear wheel brake first and then the front wheel brake.
Make sure that the brakes are tight. If the brakes are too loose, tighten them with an Allan key. When riding
in the rain or snow, make sure to increase the braking distance.
Applicable age: Riding between 16 and 65 years.
Please always wear a helmet when riding your bike, obey the traffic rules and do not ride on motorway and
roads with lots of pedestrians. Please check the tyre pressure before riding.
The recommended tyre pressure is 50-75 PSI.
When riding downhill and on unpaved roads, ensure that the speed does not exceed 15 km/h. When using
the motor, be careful not to hit it too hard and keep the rotation shaft lubricated. It is not allowed to ride with
more than the maximum body load (the maximum load is 120 KG) After use, the bike cannot be parked in
the building hall, evacuation stairs, safety exits, and must be properly parked in accordance with the safety
rules.
Riding
Deutsch / English / Français / Español / Italiano / Nederlands / Polski
-51-

Table of Contents

Related product manuals