1
6. Accessory Assembly
3. Insert the seat tube and adjust to the desired
height (note: insert the seat tube to a depth that is
buried past the safety scale).
Note: The depth of insertion of the seat tube should
be buried past the safety scale.
4. Press the quick release wrench in the direction
shown
Note: If the folding spanner is too tight or too
loose, please adjust the screw at "1" appropriate-
ly.
1. Snap the wheel reflector into the spokes (note that
the spokes should be embedded in the slot in the
middle of the wheel reflector).
2. Turn in the reflector catch and secure the
tight wheel reflector by turning it approximately
90 degrees with the one-touch screwdriver in
the 16-in-1 tool.
3. Using the Phillips screwdriver in the 16 in 1 tool,
loosen the screw on the bell holder.
4. Insert the bell holder into the handlebar in the
appropriate position.
Use a Phillips screwdriver to lock the screws.
Deutsch / English / Français / Español / Italiano / Nederlands / Polski
-59-
To Next Page
