10 AG-21213-F-09-09
DE
GB
F
NL
5.1 RINSE AID
– Place the suction hose (blue marking) into the rinse aid container.
Fill the suction hose according to chapter 6.5.
5.2 DETERGENT
Do not use any acidic detergent products with the built-in detergent
pump! (The ph-value has to be higher than 7.)
– Place the suction hose (clear) into the detergent container.
Fill the suction hose according to chapter 6.4.
The maximum suction head of the dosage pumps is
1.5 meters. Do not confuse the containers !
Use only commercial detergent and rinse aid. Please pay attention to
the manufacturers safety instructions.
5.3 SOFTENER (only on option)
The machine will be delivered without salt. For the first run, the softener
has to be filled with salt and water.
– Open the door.
– Unscrew the softener lid and fill the softener with 2 kg of "Granular
regeneration salt" (do not use salt tablets).
– Fill up the softener with potable water.
Clean seal and rim of softener lid carefully, before closing the lid.
– Close lid and tighten.
5.4 FILLING OF THE RINSE BOOSTER HEATER AND
DETERGENT PRE-DOSING
– Close the door.
– Open shut-off valve.
– Switch on main switch or put the plug in.
– Push the ON/OFF button
À
, the button illuminates.
At the temperature indicator Rinse
Å
, "boF" appears and flashes.
The rinse booster heater has to be filled as follows.
– Push the ON/OFF button
À
again to switch off the machine.
– Open the door, push Program button
Ã
and Drain button
Â
simulta-
neously until "boF" appears again at the temperature indicator Rinse
Å
.
– Push Start button
Á
.
At the temperature indicator Wash
Ä
, "- - 1" appears.
Wait until the indicator displays "- - 0".
– Close the door.
The machine switches off and is now ready for operation.
5 START-UP
To Next Page
Loading...
