AG-21213-F-09-09 19
DE
GB
F
NL
TROUBLESHOOTING GUIDE
TYPE OF FAILURE POSSIBLE CAUSE REMEDY
Poor wash result
Stripes and staines on
dishes or glasses.
Rinse aid concentration too high. Reduce quantity (see instructions).
Hard water or high mineral content. Check water quality.
Obtain details from local water authority.
Recommended values:
Ideal degree of hardness is 4° Clark.
Ideal conductivity value for washware made of stain-
less steel max. 80 µS/cm and for dishes max. 400
µS/cm.
Insufficient rinse aid concentration
causes staines
Increase quantity (see instructions)
Machine with softener:
wrong type of salt used.
Use only granular regeneration salt.
Trouble with foam
Machine gets much louder
during wash cycle.
Foam production above average caused
by unsuitable detergent and rinse aid.
Use suitable detergent and rinse aid.
Foam production above average caused
by contact of foam producing
substances (albumins etc.).
Pre-clean washware.
Other malfunctions
Machine suddenly stops
during wash program.
Machine is connected to an energy
management system which cuts out the
energy consumer at a given point, or
machine is interlocked with another
energy consumer unit.
Connect machine separately (call electrician).
Blown site fuse. Check site fuses.
If no button is pressed, the machine automatically switches off after 6 hours without draining.
Follow the description below during the next switch on:
– Push the ON/OFF-button
À
.
– Push the Drain-button
Â
and wait until the machine is drained and switches off.
– Restart the machine as described in chapter 7.
To Next Page
Loading...
