18 AG-21213-F-09-09
DE
GB
F
NL
14 TROUBLESHOOTING GUIDE
TYPE OF FAILURE POSSIBLE CAUSE REMEDY
Poor wash result
Washware is not clean. Wash arms blocked (you should be able
to turn them easily by hand).
Take out wash arms and clean them thoroughly.
Check water outlet from machine to wash arms is
clear.
Wash arm nozzles are clogged
(visual check).
Take out wash arm, remove cleaning cap and rinse
wash arm thoroughly until soil is removed.
Replace correctly.
Rinse arm nozzles are clogged
(possibly by lime deposit)
Remove rinse arms and decalcify them in separate
container.
Detergent concentration is too low or too
high.
Check setting of detergent concentration.
See also operating instructions point 6.1.
Coarse strainer soiled. Take out strainer, empty and clean it.
Fine strainer soiled or obstructed by
lime.
Take out fine strainer. If heavily soiled soak in a
vinegar solution. Then clean it thoroughly until the
pores are free.
Cleaning is to be done daily (see operating
instructions).
Wrong program selected for heavily
soiled washware.
Select program with longer wash cycle.
Washware does not dry
properly.
Rinse aid concentration too low. Increase concentration.
See also operating instructions point 6.2.
Washware still greasy. 1. Detergent concentration too low: increase
(see instructions).
2. Check if detergent is appropriate. If not choose
a stronger one.
3. Drain soiled water and refill machine.
Check pre-scrapping procedure.
Washware stays too long in the machine
at the end of program.
Take out washware as soon as cycle is completed to
enable them to dry.
To Next Page
Loading...
