À
Machine ON / OFF
(illuminates during
operation)
By pushing this button the machine will be switched on.
In case of emergency (e.g. faults), it is possible to switch off the machine
immediately without drain cycle, by pushing this button again.
After switch off, the machine is not voltage free!
Á
Start button
By pushing this button the wash cycle will be started. Furthermore the button
illuminates to indicate the mode of the machine.
RED
GREEN
BLUE
GREEN
RED/BLUE
(permanent)
(permanent)
(permanent)
(flashing)
(alternate flashing)
= Machine fills and starts heating
= Machine is ready for operation
= Wash cycle is running
= Wash cycle finished, exhaust heat
recovery is running (Option)
= Blocked filter warning.
Refer to "Faults" chapter 13
Only for machines with switchable washing pressure (optional):
High-pressure mode for a running cycle is activated by briefly pushing the blue
illuminated Start button (not possible within the first 5 seconds after cycle start).
By pushing the Start button and holding (3 sec.), high-pressure mode is perma-
nently activated.
Â
Drain button
(illuminates during
operation)
By pushing and holding (2 sec.) this button, the drain and self cleaning cycle
starts. At the end of the cycle, the machine switches off automatically.
After switch off, the machine is not voltage free!
Ã
Program-button
By pushing this button, it is possible to select between different pre-set
programs, according to the model and equipment. The program no. (e.g. P02)
appears at the rinse temperature indicator
Å
.
Ä
Temperature indicator
Wash (°C)
Indicates only on demand (see chapter 8).
Å
Temperature indicator
Rinse (°C)
Indicates only on demand (see chapter 8).
Æ
Salt required
Indicates the need for regeneration salt to be added. (Only with built-in softener.)
Ç
Service indicator
Indicates that the machine has a fault.
To Next Page
Loading...
