AG-21213-F-09-09 11
DE
GB
F
NL
ATTENTION:
The machine has to be switched off.
– Open the door, push Program button
Ã
and Drain button
Â
simultaneously until "boF" appears at the temperature indicator
Rinse
Å
.
If the door is closed or if no button is pressed for 10 seconds,
the indicator automatically switches off and the new settings are
saved.
6.1 ADJUSTMENT OF DETERGENT DOSAGE QUANTITY
(delivery values are only valid with built-in HOBART detergent pump)
The temperature indicator Rinse
Å
displays:
"CH1" = adjustment of the detergent dosage quantity.
The temperature indicator Wash
Ä
displays e.g.:
"20" = pre-adjusted value of the detergent dosage time =
20 sec. ≈ 3.0 g/l.
– To adjust the detergent dosage time, push Start button
Á
repeatedly
until the desired value (0 - 50 sec. ≈ 0 - 7.6 g/l)
appears at the Wash indicator
Ä
.
Adjustment should be done in accordance with chemical suppliers
recommendations.
6.2 ADJUSTMENT OF RINSE AID DOSAGE QUANTITY
Push Program button
Ã
again.
The temperature indicator Rinse
Å
displays:
"CH2" = adjustment of the rinse aid dosage quantity.
The temperature indicator Wash
Ä
displays e.g.:
"24" = pre-adjusted value of the rinse aid dosage time =
24 sec. ≈ 0.5 g/l.
– To adjust the rinse aid dosage time, push Start button
Á
repeatedly, until the desired value (0 - 50 sec. ≈ 0 - 1.0 g/l) appears at
the Wash indicator
Ä
.
Adjustment should be done in accordance with chemical suppliers
recommendations.
6.3 ADJUSTMENT OF WATER HARDNESS
With optional softener only.
To adjust the softener to the local water hardness, (obtain details from
local water authority):
– Push Program button
Ã
again.
The temperature indicator Rinse
Å
displays:
"H02" = adjustment of the softener (if built in)
Push Start button
Á
repeatedly until the required value
(H01 - H03) appears at the temperature indicator Rinse
Å
.
H01 = up to 12° eh / H02 = 13 to 25° eh / H03 = 26 to 37° eh
water hardness (eh = Clark).
6 SETTINGS
To Next Page
Loading...
