Holden Colorado Owner Manual (Holden-Localizing-Australia/New Zealand-
13711071) - 2020 - CRC - 3/4/19
194 Driving and Operating
If pressed, DCS operation will
stop until the accelerator or
brake pedals are released.
5 stops flashing.
.
If the DCS is activated and the
vehicle speed exceeds
30 km/h,
5 extinguishes and the
system remains in
standby mode.
When the vehicle speed drops
below approximately 30 km/h,
5
illuminates and DCS is
activated.
.
When in standby mode and the
vehicle speed exceeds 50 km/h,
DCS deactivates.
.
The message Reduce Speed for
Hill Descent Control may display
when DCS is activated and
vehicle speed exceeds 30 km/h.
Deactivation
While travelling at speeds below
50 km/h:
.
Press
5
5
extinguishes.
System Protection
When operated continuously for
prolonged periods of time,
temperatures may increase within
the brake system:
.
DCS may enter a protection
mode, gradually releasing the
brakes, and temporarily
disabling DCS.
.
5 will extinguish.
.
Traction Control Off may display
on the DIC.
.
All other braking functions will
continue to operate normally.
.
Once the brakes are at normal
temperatures, press
5 at
speeds below 50 km/h to
reactivate the DCS.
Cruise Control
The vehicle may have cruise
control.
The cruise control:
.
Maintains the vehicle's speed
without pressure on the
accelerator pedal.
.
Will only operate at speeds
above approximately 20 km/h.
.
Controls are located on the
steering wheel.
To Next Page
Loading...
