Holden Colorado Owner Manual (Holden-Localizing-Australia/New Zealand-
13711071) - 2020 - CRC - 3/4/19
Vehicle Care 247
If driving in snowy conditions with a
snorkel, see Snorkel Intake under
Add-On Electrical Equipment 0 213.
Tyre Changing
{
Warning
All passengers must be out of the
vehicle when it is being jacked.
Do not jack a vehicle with a trailer
attached. Remove the trailer first.
Only jack the vehicle on hard,
level surfaces.
Ensure moving parts of the jack
are adequately lubricated
before use.
Use the jack only at the
designated lifting points. Use in
other locations may result in the
vehicle falling off the jack,
or damage to the vehicle.
Do not start or run the engine
while the vehicle is supported by
the jack.
(Continued)
Warning (Continued)
Use the jack only for lifting the
vehicle when changing wheels.
Do not get under a vehicle that is
supported by a jack. No person
should place any portion of their
body under a vehicle that is
supported by a jack.
Vehicles with alloy wheels may
have a steel spare wheel. Drive
carefully and do not exceed
80 km/h if the tyre size or tread
pattern of the spare tyre is
different to the other tyres on the
vehicle. Although the spare tyre
was fully inflated when the vehicle
was new, it can lose air over time.
Check the inflation pressure
regularly.
After installing the spare tyre on
the vehicle, stop as soon as
possible to check the inflation
pressure is correct. Have the flat
(Continued)
Warning (Continued)
tyre repaired or replaced and
installed back on the vehicle as
soon as possible.
1. Park on a hard, level surface,
in a safe location.
2. Apply the park brake firmly.
3. Place manual transmission in
first or reverse gear.
Place automatic transmission
in P.
4. Switch the hazard warning
flashers on.
5. Turn off the engine and remove
the key.
6. Chock the wheel diagonally
opposite the flat tyre with a
suitable solid object.
Note
Do not change more than one wheel
at one time.
7. Remove the tools. See Tools
0 239.