Holden Colorado Owner Manual (Holden-Localizing-Australia/New Zealand-
13711071) - 2020 - CRC - 3/4/19
78 Lighting
If the windscreen wipers operate
eight continuous cycles when it is
dark outside, the exterior lamps
illuminate automatically.
Headlamp High/
Low-Beam Changer
{
Warning
Always switch the high beam
headlamps to low beam when you
approach oncoming or other
vehicles ahead. High beam
headlamps can temporarily
dazzle other drivers, which could
result in a collision.
To activate high beam:
.
When the headlamps are on,
push the turn signal lever away
from you.
The high-beam on light
illuminates in the instrument
cluster.
To return to low beam:
.
Pull the lever towards you.
To flash the high beam lamps:
.
Pull the turn signal lever towards
you and release.
The lamps remain on high beam
for as long as the lever is pulled.
When the lever is released, the
headlamps return to their
previous state, e.g. low beam if
they were on, or off.
Daytime Running
Lamps (DRL)
DRL increase the visibility of the
vehicle during daylight. The LEDs in
the DRL can operate in two different
intensities:
.
Normal intensity for position
(parking) lamps.
.
High intensity for DRL function.
The DRL operate in high intensity in
the following conditions:
.
The ignition is in the ON/RUN
position.
.
The exterior lamp control is in
the AUTO position.
.
The engine is running and the
shift lever is not in P.
To Next Page
Loading...
