Holden Colorado Owner Manual (Holden-Localizing-Australia/New Zealand-
13711071) - 2020 - CRC - 3/4/19
64 Instruments and Controls
Electronic Stability
Control (ESC) Indicator
Light
.
The
G warning light illuminates
for a short time when the ignition
is turned on to show that the
light is working.
.
The light flashes while driving, to
show that the ESC is actively
helping the vehicle with road grip
and stability.
.
If the light illuminates or does
not extinguish while driving,
contact a Holden Dealer
immediately.
.
See Driver Information Centre
(DIC) 0 67 and
Electronic Stability Control
(ESC) 0 192.
Electronic Stability
Control (ESC) Off Light
.
The
g warning light illuminates
for a short time when the ignition
is turned on to show that the
light is working.
.
If the light does not illuminate,
contact a Holden Dealer.
.
g illuminates when the ESC is
deactivated.
.
See Driver Information Centre
(DIC) 0 67 and
Electronic Stability Control
(ESC) 0 192.
Traction Control System
Warning Light
G illuminates or flashes amber.
Illuminates
Illuminates for a few seconds after
the ignition is switched on. If the
system is working normally, the
indicator goes out.
If the indicator does not go out after
a few seconds, there is a fault in the
system. It is possible to keep driving
without Traction Control System
(TCS) activated.
Have the cause of the fault fixed by
a Holden dealer.
Flashes
The indicator will flash during TCS,
Electronic Stability Control (ESC)
and/or Trailer Sway Control (TSC)
activation.
See Traction Control System (TCS)
0 191. See Electronic Stability
Control (ESC) 0 192. See Trailer
Sway Control (TSC) 0 212
Traction Control System
(TCS) Off Light
i
illuminates amber.
Illuminates when the system is
deactivated.
See Traction Control System (TCS)
0 191.
To Next Page
Loading...
