Holden Colorado Owner Manual (Holden-Localizing-Australia/New Zealand-
13711071) - 2020 - CRC - 3/4/19
68 Instruments and Controls
Tyre Load
This display shows the current tyre
load. The tyre loads that can be
selected are:
Light : Light loaded vehicle.
ECO : Best Economy.
Max : Heavy loaded vehicle.
Transmission Fluid Temperature
Displays the current transmission
fluid temperature.
Speed Warning
This mode allows you to set a
warning signal for when a desired
speed is exceeded.
To set the speed warning, press the
SET/CLR button and use the thumb
wheel to select the desired speed.
Press SET/CLR to confirm.
Remaining Oil Life
Displays the current percentage of
remaining oil life.
To reset the engine oil life system
see Engine Oil Life System 0 222.
Tyre Pressure
Displays the current tyre pressure.
Trip Pages
.
Digital Speedometer.
.
Combined Trip 1 and Trip 2.
.
Fuel Range.
.
Instantaneous fuel economy.
.
Timer.
.
Outside Air Temperature.
Digital Speedometer
Indicates the vehicle speed.
Combined Trip 1 and Trip 2
Displays the current distance
travelled, average vehicle fuel
consumption and average vehicle
speed since the last reset.
To reset, press and hold the SET/
CLR button.
Fuel Range
The Fuel Range display shows the
approximate distance the vehicle
can be driven without refuelling.
The fuel range estimate is based on
an average of the vehicle fuel
economy over recent driving history
and the amount of fuel remaining in
the fuel tank.
When the fuel range estimate is less
than 64 km, a Fuel Level Low
message will appear on the Driver
Information Centre and the low fuel
control indicator will start to flash.
See Low Fuel Warning Light 0 65.
The distance can vary depending on
driving patterns.
Note
The display may differ from the
actual distance for remaining fuel
depending upon circumstances.
The driving distance for remaining
fuel can change by the driver
behaviour, the road conditions and
the vehicle speed as it is calculated
according to the changing fuel
efficiency.
To Next Page
Loading...
