IMAGER DUO SYSTEM INSTALLATION
2.4
Imager Duo Operator’s Manual
placed on the floor near the work area, provided it has adequate air circulation
to prevent dust accumulation and it is safely removed from foot traffic or other
interference. It should be accessible for routine maintenance.
The network printer will be installed and set up at the time of instrument instal-
lation. Please refer to the manufacturer’s guide for operation and maintenance.
Note:
The uninterruptable power supply (UPS) provides battery backup
power for a period of time (up to 30 minutes for a fully charged battery)
in the event of a power outage. Slides will be stored and the robotic arm
is safely parked. The operator may then shut down the Imaging System
(refer to page 3.29).
WARNING
Grounded Outlet
The uninterruptable power supply will be installed and setup at the time of
instrument installation. Please refer to the manufacturer’s guide for proper
operation, maintenance and disposal.
STORAGE AND HANDLING - POST INSTALLATION
Environmental Considerations
• The Imaging Station and the Image Processor Controller are sensitive to
sudden thermal or humidity changes. Do not locate them next to win-
dows, heaters, air conditioners, HVAC vents or doors that are frequently
opened and shut.
• During operation, the Imaging Station is sensitive to vibrations. It should
be placed on a sturdy flat surface away from centrifuges, vortexors or
any equipment that may cause vibrations. Keep away from other envi-
ronmental activity, such as constant foot traffic, proximity to elevators or
doors that are frequently open and shut.
To Next Page
Loading...
