OPERATION OF THE IMAGER DUO
3.18
Imager Duo Operator’s Manual
Figure 3-19 Typical Event Log Display
If a slide caused an event during processing, the operator should check it at the
conclusion of the batch to determine if there is any corrective action that would
allow it to be successfully processed in another batch. This may include:
• Slide incorrectly loaded into the slide cassette
• Slide was not completely dry when loaded into the cassette
• Mounting media was on the frosted portion of the slide
• Slide contains bubbles
• Slide coverslip protrudes over the edge & causes interference
• Slide not labeled for use with the Imager Duo
To Next Page
Loading...
