2.
TROUBLESHOOTING
Air
-*
a.
GAS ASSISTED TILT
Bleed air and recheck:
Loosen the manual valve and move
the piston rod back and forth several
times, then tighten the manual valve.
Clean and lubricate:
(P.
12-16).
Faulty gas assiste
Replace:
(P.
12-14, 16).
Does
not
hold
Tilt lever is in TILT position.
Turn to RUN position.
Li
Faulty gas assisted tilt.
Replace: (P. 12-4, 16).
b.
POWER
TILT
Power
Tilt
Does
Not
Move
I
Sound.
Turn" TROUBLESHOOTING on page
1
2-4.
1
Check the manual release valve.
+
Loose
-1
Tighten the manual valve securely.
1
I
.1
Tight
Check for oil leakage from each mating
part.
Replace the O-ring and/or oil seal at
Leaking
-r
the leaking point
(P.
2-5, 6).
I
Not leaking
I
Check the oil level with the piston rod
fully extended (P. 12-39).
Normal
i
1
Check for air in the system.
No
air
Faulty power tilt assembly.
Check and repair the power tilt
assembly according to the table on
.
page 2-5.
Low
-1
Fill with recommended oil
(P.
12-39).
2-2