N3680 Decoded Engine User Guide 103
When Check Character is set to Validate Type 10/11, but Don’t Transmit, the unit
will only read MSI bar codes printed with the specified type check character(s), but
will not transmit the check character(s) with the scanned data.
MSI Message Length
Scan the bar codes below to change the message length. Refer to Message Length
Description (page 76) for additional information. Minimum and Maximum lengths
= 4-48. Minimum Default = 4, Maximum Default = 48.
* Validate Type 10, but Don’t
Transmit
Validate Type 10 and Transmit
Validate 2 Type 10 Characters,
but Don’t Transmit
Validate 2 Type 10 Characters
and Transmit
Validate Type 11 then Type 10
Character, but Don’t Transmit
Validate Type 11 then
Type 10 Character and Transmit
Disable MSI Check Characters
To Next Page
Loading...
Need help?
General