N3680 Decoded Engine User Guide 43
Scan the Hands Free Time-Out bar code, then scan the time-out duration (from 0-
300,000 milliseconds) from the inside back cover, and Save. Default = 5,000 ms.
Reread Delay
This sets the time period before the scan engine can read the same bar code a sec-
ond time. Setting a reread delay protects against accidental rereads of the same
bar code. Longer delays are effective in minimizing accidental rereads. Use shorter
delays in applications where repetitive bar code scanning is required. Reread Delay
only works when in a Presentation Mode (see page 37). Default = Medium.
User-Specified Reread Delay
If you want to set your own length for the reread delay, scan the bar code below,
then set the delay (from 0-30,000 milliseconds) by scanning digits from the inside
back cover, then scanning Save.
User-Specified Reread Delay
To Next Page
Loading...
