112 N3680 Decoded Engine User Guide
the number of QR Code bar codes determined by information encoded in those bar
codes. Once the proper number of codes is reached, the data is output in the order
specified in the bar codes. There are 3 ways to scan appended QR Code:
• One scan—Pull the trigger one time and all appended QR Codes in the same
image are decoded
• Swipe—Pull and hold down the trigger and scan all appended QR Codes while
keeping the trigger pressed. The scanner emits short beeps for each partial QR
Code that is scanned and buffered. One long beep is emitted after the last QR
Code is scanned and the data is complete. Not compatible with Presentation
mode.
• Point and shoot—Pull the trigger one time for each image. The scanner emits a
short beep for each partial QR Code that is scanned and buffered. One long beep
is emitted after the last QR Code is scanned and the data is complete. Not
compatible with Presentation mode.
Default = One Scan.
QR Code Page
QR Code pages define the mapping of character codes to characters. If the data
received does not display with the proper characters, it may be because the bar
code being scanned was created using a code page that is different from the one
the host program is expecting. If this is the case, scan the bar code below, select
the code page with which the bar codes were created (see ISO 2022/ISO 646
Character Replacements on page 180), and scan the value and the Save bar code
from the Programming Chart on the inside the back cover of this manual. The data
characters should then appear properly.
To Next Page
Loading...
