64 N3680 Decoded Engine User Guide
Data Format Editor Commands
When working with the Data Format Editor, a virtual cursor is moved along your
input data string. The following commands are used to both move this cursor to
different positions, and to select, replace, and insert data into the final output.
Send Commands
F1—Send All Characters
Include in the output message all of the characters from the input message, start-
ing from current cursor position, followed by an insert character. Syntax = F1xx
where xx stands for the insert character’s hex value for its ASCII code. Refer to the
ASCII Conversion Chart (Code Page 1252), beginning on page 174 for decimal, hex
and character codes.
F2—Send a Number of Characters
Include in the output message a number of characters followed by an insert char-
acter. Start from the current cursor position and continue for “nn” characters or
through the last character in the input message, followed by character “xx.” Syntax
= F2nnxx where nn stands for the numeric value (00-99) for the number of charac-
ters, and xx stands for the insert character’s hex value for its ASCII code. Refer to
the ASCII Conversion Chart (Code Page 1252), beginning on page 174 for decimal,
hex and character codes.
Example: Send a number of characters
Terminal ID Table
Terminal Model(s) Terminal ID
USB PC keyboard (HID) 124
Mac Keyboard 125
PC Keyboard (Japanese) 134
Serial (COM driver required) 130
HID POS 131
USB SurePOS Handheld 128
USB SurePOS Tabletop 129
Serial RS232 TTL 000
RS232 True 000
RS485 (IBM-HHBCR 1+2, 46xx) 051
Keyboard PS2 compatibles 003
AT compatibles 002
To Next Page
Loading...
