Honeywell CF3680 - Aztec Code Message Length; Aztec Append

N3680 Decoded Engine User Guide 115
Aztec Code Message Length
Scan the bar codes below to change the message length. Refer to Message Length
Description (page 76) for additional information. Minimum and Maximum lengths
= 1-3832. Minimum Default = 1, Maximum Default = 3832.
Aztec Append
This function allows the scanner to append the data from several Aztec bar codes
together before transmitting them to the host computer. When the scanner
encounters an Aztec bar code with the append trigger character(s), it buffers the
number of Aztec bar codes determined by information encoded in those bar codes.
Once the proper number of codes is reached, the data is output in the order speci-
fied in the bar codes. There are 3 ways to scan appended Aztec Code:
• One scan—Pull the trigger one time and all appended Aztec Codes in the same
image are decoded
• Swipe—Pull and hold down the trigger and scan all appended Aztec Codes while
keeping the trigger pressed. The scanner emits short beeps for each partial
Aztec Code that is scanned and buffered. One long beep is emitted after the last
Aztec Code is scanned and the data is complete. Not compatible with
Presentation mode.
• Point and shoot—Pull the trigger one time for each image. The scanner emits a
short beep for each partial Aztec Code that is scanned and buffered. One long
beep is emitted after the last Aztec Code is scanned and the data is complete.
Not compatible with Presentation mode.
Default = One Scan.
Off
Minimum Message Length
Maximum Message Length
* One Scan