N3680 Decoded Engine User Guide 83
When Check Digit is set to Validate and Transmit, the scanner only reads Inter-
leaved 2 of 5 bar codes printed with a check digit, and will transmit this digit at the
end of the scanned data. Default = No Check Digit.
Interleaved 2 of 5 Message Length
Scan the bar codes below to change the message length. Refer to Message Length
Description (page 76) for additional information. Minimum and Maximum lengths
= 2-80. Minimum Default = 4, Maximum Default = 80.
NEC 2 of 5
< Default All NEC 2 of 5 Settings >
NEC 2 of 5 On/Off
Validate, but Don’t Transmit
To Next Page
Loading...
Need help?
General