IFP-75 Series Manual — P/N LS10147-001SK-E:E 4/6/2022 27
Mounting the Control Panel Cabinet Control Panel Installation
3. Close the dead front panel. The bottom two screws on the annunciator will protrude through the dead front panel.
4. Reinstall the top two annunciator screws removed in step 1.
5. Insert the two screws with the star washers into the bottom of the cabinet to secure the dead front to the cabinet.
Dead Front Removal
Follow these steps to properly remove the dead front panel from the control panel cabinet.
1. Remove the top two annunciator screws. See Figure 4.2 for location.
2. Remove the two screws and star washers from the bottom of the cabinet.
3. Remove the dead front panel from the control panel cabinet.
4. Reinstall the top two annunciator screws to secure to the board.
Figure 4.2 Dead Front Installation and Removal
remove top two annunciator screws from
board and secure through dead front panel
bottom two screws protrude
through dead front
secure to cabinet with
screws and star washers
To Next Page
Loading...
