128 MS-5UD & MS-10UD Series Manual — P/N 52626:C7 6/12/2018
Appendix F: Canadian Applications
F.1 ANN-LED Annunciator Installation for Canadian Applications
• The FACP is supplied with a modified dress panel and one ANN-LED annunciator.
• When installing and programming the FACP, the Canadian Option must be set to ON prior to any other panel programming (refer to
“Canadian Option” on page 70 of the Programming Section of this manual).
• If remote indicators are desired, they must be connected to the secondary ANN-BUS circuit. This requires the use of the ANN-SE
C
option card.
•
The installer must write in the Date of Final Assembly on the Master Marking and Warranty Label located on the FACP back
box
door.
•
To comply with CAN/ULC-S559-04, the ANN-RLY option must be utilized along with the configuration shown in Figure F.
2.
Figure F.1 Canadian FACP Configuration
FACP
ANN-LED Annunciator
on Primary ANN-BUS
510-annled.wmf
ANN-LED
ANN-80C
ANN-I/O
ANN-S/PG
ANN-RLY
Optional Secondary
ANN-BUS using
ANN-SEC Option Card.
To Next Page
Loading...
Need help?
General
