Honeywell Galaxy Dimension series - Page 23

Preconfiguration checklist
gtap.genetec.com | Honeywell Galaxy Control Panel Integration Guide 5.2 18
EN.550.007-V5.2.C4(3) | Last updated: March 11, 2014
 Set the Access period option to Any Time.
Setting the access period to Any Time allows Security Center to access the Galaxy
Dimension control panel at any time. For more information, see “56.4.3.1 - Access
Period” in the Honeywell Galaxy Dimension Installer Manual.
 Set the access Mode to Direct Access.
Setting the Mode to Direct access allows Security Center to initiate the remote
connection with the control panel. For more information, see “56.4.3.2 - Mode” in the
Honeywell Galaxy Dimension Installer Manual.
10 For the SIA Control option, enter the IP address of the computer sending SIA events.
Set this option so the SIA controls sent from the control panel to Security Center are
recognized by the Ethernet module.
For more information about setting the SIA Control option, see “56.4.8 - SIA Control” in
the Honeywell Galaxy Dimension Installer Manual.