Honeywell Galaxy Dimension series Integration Guide

Map Galaxy panel events to Security Center actions
gtap.genetec.com | Honeywell Galaxy Control Panel Integration Guide 5.2 34
EN.550.007-V5.2.C4(3) | Last updated: March 11, 2014
Map Galaxy panel events to Security Center actions
Galaxy Dimension control panel events can trigger actions in Security Center. For example, a
Unit tamper event on the control panel can trigger a Security Center alarm.
NOTE Output pins on the control panel only support the Trigger output action.
1 From the Home page in Config Tool, open the System task.
2 Click the General settings view, and click the Actions page.
3 In the Actions page, click .
4 In the Entity type page, select Intrusion detection unit or Intrusion detection area, and
click Next.
5 In the Source page, select a unit or area, and click Next.
6 In the Event page, select an event.
The default schedule is Always. If necessary, you can change the default schedule.
NOTE If you created custom events in the intrusion detection unit Properties tab, then they
are available in the event list. For more information, see "Map inputs to intrusion detection
areas" on page 27.
7 Click Next.

Honeywell Galaxy Dimension series Specifications

General

Model	Galaxy Dimension series
Users	Up to 250
Partitions	Up to 8
Operating Temperature	-10°C to +55°C
Compatibility	Honeywell Galaxy accessories and peripherals