Create the Intrusion Manager role
gtap.genetec.com | Honeywell Galaxy Control Panel Integration Guide 5.2 20
EN.550.007-V5.2.C4(3) | Last updated: March 11, 2014
d Click Next.
5 On the Creation summary page, do the following:
a Verify the information you entered.
b If everything is correct, click Create, or click Back to modify your settings.
When the role is created, the following message appears: The operation was successful.
6 Click Close.
The Intrusion Manager role appears in your entity browser.
For more information about configuring Intrusion Manager role properties, see “Intrusion
Manager” in the Security Center Administrator Guide. You can access this guide by clicking F1
in Config Tool.
After you are done: "Create the Intrusion detection unit" on page 21.
To Next Page
Loading...
