Honeywell HEN322 4 Series User Manual

Performance Series Network Video Recorder User Guide
146
12 Web Client Operation
This chapter describes how to access Honeywell’s Performance Series Network Video
Recorder remotely using a browser-based web client.
This chapter is intended for remote users of the NVRs.
Logging In
This chapter includes:
• PC requirements for the web client software
• Logging in to the web client software
• The web client software’s main page
Preparing to Use the Device Web Client
PC Requirements
Table 12-1 PC Requirements
Component Minimum Requirement
Processor Quad core
System memory (RAM) 2G or higher
Non-integrated video card 256M or higher
Before You Log In
Ensure that the following conditions are met:
• Ensure that the network connection is good.
• Ensure that the NVR and PC network setup is correct. See the network setup: Main Menu
 Setting  Network.
• Ping to ensure that the network connection is good. Ping *** *** *** *** (where *** *** *** ***
is the NVR’s IP address). The return TTL should be less than 225.
Note
Before you uninstall the web control, close all web pages. If you do not, then the
uninstallation procedure might result in an error.

Honeywell HEN322 4 Series Specifications

General

Brand	Honeywell
Model	HEN322 4 Series
Category	Network Hardware
Language	English