Web Client Operation
195
Figure 12-65 Camera Tampering Configuration Interface
The configuration for Camera Tampering Detection is very similar to the configuration for
Motion Detection. Please see Motion Detection Configurations on page 190 for more
information.
Camera Scene Change Configurations
Note
This function is not available for
HEN041*3/HEN081*3/HEN161*3/HEN04103L/HEN08103L/HEN1
6103L/HEN32103L on the web client. If you want to change this
setting, go to the local client.
1. Click Video Detection Scene Change under EVENT to open the Scene Change
configuration interface.
2. Setup the scene change settings and click OK to save the settings.
Figure 12-66 Camera Scene Change Configuration Interface
To Next Page
Loading...