TrueSTEAM™
PROFESSIONAL INSTALLATION GUIDE • GUIDE D’INSTALLATION PROFESSIONNELLE
Included In thIs humIdIfIer Box
matérIel comprIs dans l’emBallage
Remote installation requires separate purchase of the
Honeywell Remote Mounting Kit (#50024917)
Wire cutter/stripper
1-3/4-in. diameter hole saw
1/8-in. drill bit
Standard screwdriver
18-gauge wire (up to 5 conductor)
Torx driver T-20 and T-30
TrueSTEAM flushes water at or above 140°F (60°C).
Refer to local codes for proper draining practices
for hot water.
Condensate pump rating of 212°F (100°C) if used.
Drip pan with water sensor shut-off required underneath
TrueSTEAM if installed in or above finished space.
TrueSTEAM
Mounting bracket and hardware
Water filter and backflow preventer
Saddle valve
e
Water supply hose
f
Drain hose (10 feet)
g
Duct nozzle and gasket
h
Owner’s manual
I
Service label
J1
Prestige HD color control*
J2
TrueIAQ control*
J3
Humidity control*
J4
VisionPRO IAQ control*
*
Control based on model ordered.
e
h
f
I
J1 J2 J3 J4
g
GETTING
STARTED
MOUNTING PLUMBING WIRING APPENDICES
OPERATION
AND SERVICE