EasyManua.ls Logo

Honeywell HM512W1005 - STEP THREE: Connect Truesteam to the Water Pipe; STEP FOUR: Connect the Water Drain

Honeywell HM512W1005
92 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
PLUMBING
STEP THREE: Connect TrueSTEAM to the Water Pipe
Connectoneendoftheremaininglengthofwater
linetothebackowpreventer.Applyamodestpullto
ensureatightt.See “Appendix F: Reverse Osmosis
Filter” on page 42 if using the Reverse Osmosis Filter.
Connecttheotherendofthislinetothesaddlevalve
orT-ttingandmanualshutoffvalve.
STEP FOUR: Connect to the Water Drain
Consultandfollowlocalplumbingcodesfordrain•
pipesizeandmaximumtemperaturerequirement.
Theidealinstallationisdirectlytothemainoor•
drainusingtherubberhoseprovided.
Ifdirectoordrainaccessisnotavailable,• see
“Appendix E: Advanced Draining” on page 41.
Connectthe1/2-inchdrainhoseprovidedtothedrain
ttingonthebottomoftheTrueSTEAM.
Use the hose clamp provided to secure the drain hose
tothebarbedtting.
Routethedrainhosetotheoordrain.Thehosemust
haveacontinuousdownwardslope.
Directthehoseoutletintotheoordrain.Secure
thehosetoreducetheriskofhotwaterpooling
orsplashing.
M29606
M29607
Before proceeding to Wiring:
I have confirmed minimum required circuit capacity
Ihaveconnectedthewatersupplyusingcoldwater
I have installed the drain connection
CAUTION: Scalding Hazard.
During operation, hot water may exit drain and can cause burns from scalding.
Make sure the hose is securely connected to the drain.
TrueSTEAMHumidicationSystem69-2285EF—01
11
2
1
3
2
1
4

Table of Contents

Other manuals for Honeywell HM512W1005

Related product manuals