Honeywell Impact Series User Manual

Impact / Impact Pro / Impact Pro IR Operating Instructions
36
4�7�2 Operator
This allows a new operator and/or location to be selected without restarting the
instrument.
4�7�3 Calibration
See Section 4.9 Calibration for full details.
4�7�4 Instrument Details
Several screens are available detailing the instrument set-up, such as alarm levels.
These can be viewed by pressing the s and t buttons to cycle through them. To
access User Menu press 3 while in monitor mode. Scroll down to highlight Instrument
and press 3 again. Some examples are shown below and these are indicative only.
Information shown will vary according to model, country, product application and /
or specific requirements.
Software Revision
Version 2.6
Serial Number
0000000000
Calibration Due
in 34 days
This information is also available at switch-on of the
instrument (see Section 3.1 for details).
02 %V/VFLM %LEL
50
80
120
23.0
19.0
17.0
FlammableGas
Methane
A1
A2
A3
These are the alarm level settings for oxygen and
flammable sensors. There are no associated STEL or
LTEL alarms for the two gas channels displayed at the
top. h indicates a rising alarm and i indicates a falling
alarm.
50
100
150
100
50
25
50
100
50
25
A1
A2
A3
STEL
LTEL
CO ppm
H2S
ppm
This shows the alarm levels for the toxic sensors.
The following displays indicate whether particular options are fitted and how the
instrument is currently configured.
Pump
Fitted
Data Logging
Gas
Safelink
Fitted
Last Calibration
1 Jan 2001
Autozero
Enabled
GasAlarms
Latched
Battery
Rechargeable
Vibrating Alarm
Enabled
Language
English
The following additional information is also displayed:
Cartridge SN
0001138
Date of Manufacture
25/Jun/2001
Boot ROM Version
Impact Boot 1.4+
Cartridge Type
Standard
Install By
26/Dec/2001
Date of Activation
9/Aug/2001
Honeywell Analytics
Sunrise, FL
800 538 0363

Honeywell Impact Series Specifications

General

Brand	Honeywell
Model	Impact Series
Category	Battery Charger
Language	English