Impact / Impact Pro / Impact Pro IR Operating Instructions
5
Total Environmental Solutions
Ensure that you read and understand these Operating Instructions BEFORE
installing or operating any part of the equipment.
Please pay particular attention to the Safety Warnings.
WARNING
The dry cell battery holder part no. 2302B2016/2302B0770 or rechargeable •
battery pack part no. 2302B2015/2302B0842 must not be removed, replaced
or recharged in the hazardous area.
Only the following alkaline dry cell batteries must be used in the dry cell •
holder part no. 2302B2016/2302B0770:
Duracell
®
MN1500 or Energizer
®
E91.
Rechargeable cells must not be used in the dry cell battery holder part no. •
2302B2016/2302B0770.
Do not mix rechargeable battery packs and dry cell battery packs in the same •
Impact.
The instrumentmustbeservicedonlybyqualiedpersonneltrained by•
Honeywell Analytics or by a Honeywell Analytics Appointed agent. Servicing
must be carried out only in a non-hazardous area.
The Impact must not be used in an oxygen enriched atmosphere.•
Refer to • Section 4. Operation for details of restrictions of use of the Impact
Series.
The Catalytic Flammable Sensor requires an oxygen content of greater than •
10% v/v to operate reliably. In circumstances where the oxygen content of
the sample is less than 10% v/v, the reading displayed on the Flammable
Channel should be regarded as suspect. In this situation, a Warning 54 (Low
O
2
- Flam Inaccurate) will be generated on the instrument.
While Infrared Flammable Sensors can operate in a reduced oxygen content •
environment, it is important to note that the electrochemical sensors in the
same cartridge cannot reliably operate in a low oxygen environment.
Duracell is a trademark of the Proctor & Gamble Company
Energizer is a trademark of the Eveready Battery Company, Inc.
To Next Page
Loading...
Need help?
General
