Impact / Impact Pro / Impact Pro IR Operating Instructions
55
Special Notes for Cl
2
Cartridges
It is important that you read all of the notes below before installation or use of your
new cartridge.
Installation of your Cl
2
Cartridge
Note
Cartridge Installation or Replacement must never be carried out in a
hazardous area.
If a cartridge was previously fitted to the Impact Pro into which the Cl1.
2
cartridge is to be installed, remove the Front Cover Grille using the Allen
Key provided in the bottom of the Impact Pro. Unscrew the fixing in the
center of the cartridge and lift the cartridge from the Impact Pro.
Place the Cl2.
2
cartridge into the Impact Pro and screw the cartridge fully
home using the Allen Key. Guide the cartridge if necessary using your
fingers to ensure that it is seated correctly.
Replace the Pump Seal with the one provided with your cartridge.3.
Remove the existing Filter Assembly from the inside of the Front Cover 4.
Grille by peeling it away. Take the Stainless Steel Filter assembly (supplied
in the Cartridge Kit) and remove the protective backing paper. Locate the
Filter assembly onto the locating pegs on the inside of the Front Cover
Grille and lightly press around the edge of the gasket to secure.
Replace the Front Cover Grille and refit the Allen Key into the bottom of 5.
the Impact Pro.
To complete installation of the cartridge allow at least 20 minutes before 6.
operating the Impact Pro.
After this period of time switch the Impact Pro on and accept the New 7.
Configuration when prompted to do so.