Impact / Impact Pro / Impact Pro IR Operating Instructions
49
6�6 Enforcer
(Part Number: 2302B0831 UL Version including gas cylinder)
(Part Number: 2302B1336 ATEX Version including gas cylinder)
(Part Number: 2302B0650 Enforcer only)
This test and calibration accessory is only for use with
instruments fitted with any combination of oxygen,
flammable (catalytic or IR LEL sensor), carbon
monoxide and hydrogen sulfide sensors. Its operation
is described in Section 4.9.4 Enforcer Calibration.
This is supplied complete with an Enforcer disposable,
multigas cylinder.
For EMC/RFI Enforcer is certified to EN 50270:1999 Type 1.
6�7 Enforcer Gas Cylinder
(Part Number: 2302D0833 UL Version, containing 2.5% v/v Methane)
(Part Number: 2302D0761 ATEX Version, containing 2.2% v/v Methane)
The Enforcer requires a gas cylinder with specific concentration values, and a
specific valve to maintain the required low pressure and flow rate, which enables
the Enforcer to operate quickly and simply.
6�8 Flow Adapter
(Part Number: P2302B0810)
Allows aspirator to be fitted to the instrument. It is also used
when calibrating using the instrument or a PC. It is colored
grey to differentiate it from the pump adapter. See Section
6.12 Pump Adapter Kit.
6�9 Metal Belt Clip
(Part Number: P2302D0826)
Supplied as standard. Enables the instrument to be worn
on a belt. Slides into recess at back of unit.
6�10 Instrument Webbing Clip
(Part Number: P2302B0382)
Allows the instrument to be clipped to harness webbing.