Impact / Impact Pro / Impact Pro IR Operating Instructions
47
6� Accessories
WARNING
Do not attempt to charge the battery pack in the hazardous area.
The following accessories are available for use with Impact Series.
6�1 Base Station
(Part Number: P2302B0800)
This unit provides a smart charging facility for instruments
powered by rechargeable NiMH batteries. The instrument is
simply inserted into the base station whereby it is fast
charged. The instrument controls the charging process and
will indicate when it is fully charged, and then change to a
trickle charge mode to keep the battery topped up until the
instrument is required.
The Base Station also provides a facility to connect the instrument to a PC,
for downloading of logged data, viewing or changing instrument configuration
information, or as a means of instrument calibration.
Ensure that the instrument is not inserted backwards into the Base Station. Firstly
locate the lip at the front of the instrument into the corresponding recess, and then
latch the rear catch. To release, pull back the rear catch (see Section 2.3 Charge
for First Use).
If the instrument is switched on while placed in the Base Station the instrument will
not reach full capacity (typically only 85% if switched on for the entire fast charge
period).
The Base Station accepts an input of 12VDC to 32VDC.
Base Stations may be daisy-chain linked. See Section 6.3 Base Station PSU
Link Cable.
6�2 Base Station Plinth
(Part Number: P2302B0804)
The Base Station can also be mounted on a vertical
surface or on a desk by using the optional plinth.
6�3 Base Station PSU Link Cable
(Part Number: 2302D0821)
Allows Base Stations to be linked together, to a maximum of
5, minimizing cabling and power sockets, and forming a
multibank charger.
Daisy-chained linked Base Stations require the use of Power Supply 2302D0787.
(Note: this power supply must not be used with the Offline Trickle Charger).
To Next Page
Loading...
Need help?
General
