21 74-2760—1
Force Arming Your System
When arming your system and the message POINTS NOT READY/FORCE ARM?
displays, this means one or more points are open and the system cannot be armed
normally. Use the arrow keys to display all the open security points. If you would like to
fully arm your security system, you must first close the open points. You may, however,
Force Arm the remaining points of the system and bypass the open points from
protection.
IMPORTANT
Points that are open when you Force Arm your security system are NOT
protected even when you close them after Force Arming. For full protection,
you must disarm the system, close the points, and then arm again.
Force Arming with a Protected Point Open.
What You Do What You See What Happens
View user keypad The disarmed mode is
displayed.
Press The Mode menu displays.
Press If no response is made, a
prompt message appears
advising you to enter a valid
passcode
Enter your
passcode
The system prompts you to
confirm that you want to Force
Arm. If you want to view open
points, press the DOWN
arrow key.
Press The red LED next to the UP
arrow is lit to indicate that some
security points have been
bypassed. Exit delay starts and
audible beeps until the delay
period ends. When the OK
button is not pressed, the
system times out and returns to
the current mode.
THE SMITH'S
M6942
1– AWAY ALL ON
2– AWAY PARTIAL
M6943
AWAY ALL ON
EXIT NOW
M6944A
ENTER PASSCODE
M6949
Points Not Ready
Force Arm?
M6950A
To Next Page
Loading...
Need help?
General
