55 74-2760—1
What You Do What You See What Happens
Enter your
passcode
Audible alarm stops. The system
prompts you to press OK to
reset the smoke detectors. This
will not reset four-wire smoke
detectors.
Press The mode menu displays the
first two selections.
Press down arrow
key ▼ to scroll to
"FIRE RESET".
The display scrolls to reveal
more selections.
Press the number
corresponding to
"FIRE RESET".
The four-wire smoke detectors
are reset and the system returns
to the normal mode.
Resetting Your System after a Fire Alarm
After the fire department has told you it is safe to reenter your home, use the following
procedure to reset your system. See page 10 under location of fire protection to see if
you have 2-wire or 4-wire smoke detectors.
For System with Two-Wire Smoke Detectors
What You Do What You See What Happens
Enter your
passcode
Audible alarm stops. The
system prompts you to press
OK to reset the smoke
detectors.
Press (Current mode) The security panel and smoke
detectors reset.
IMPORTANT
After you have reset your system, if the audible alarm starts again, check
each of your smoke detectors to determine which one activated the alarm.
(Look for a steady red light.) Fan the detector for 20 to 25 seconds to clear it
of possible trapped smoke. Then enter your passcode again and respeat the
process outlined above. If the alarm continues, follow the procedure outlined
in the Emergency System Shutoff section and call for service.
OK to reset
Smoke Detectors
M14238
For System with Four-Wire Smoke Detectors
OK to reset
Smoke Detectors
M14238
1– AWAY ALL ON
2– AWAY PARTIAL
M6943
6– SYSTEM TEST
7– FIRE RESET
M14239
THE SMITH'S
M6942
To Next Page
Loading...
Need help?
General
