CONFIGURING MAXPRO NVR
Configuring the Cameras
160 MAXPRO NVR 5.0 Installation and Configuration Guide
6
2. Click the Camera tab to open the Camera page.
Figure 6-35 Camera page
Note: All analog cameras that are pre-configured in the factory image appear in the
Camera page when you first open it.
3. Under the Camera pane, select a camera to change the default parameters for the
following settings.
• Enable/Disable - Enables or disables a camera for recording and live video. By
default the check box corresponding to a camera to enable live video preview is
selected. To disable live video preview, clear the check box corresponding to a
camera. The live video appears under Video Preview at the bottom right corner of
the Camera page.
• Number - Displays the camera number. You cannot modify the camera number.
To Next Page
Loading...
