Honeywell ML200 Series User Manual

Code Error Causes
Measures
Restart mode after the
measure.
Operation
Status
LED
Status
Diagnostic
Timing
still exists after turning it
on again.
turning it
on.
13 Abnormal base
information
Contact A/S service if it
still exists after turning it
on again.
STOP ERR : On When
turning it on
converting
to RUN
mode.
22 The program of
backup flash is
defective
Restart after modifying
the program of the
backup flash.
Fault ERR : On Reset
converting
to RUN
mode.
23 If a program to
execute is not
normal
Operate after the
program is
reloaded.Replace a
battery in case of
abnormal battery.
After a program is
reloaded, check the
storage condition and if
any fault is found,
replace the CPU
module.
STOP ERR : On Reset
converting
to RUN
mode.
24 Abnormal I/O
parameter
Restart after I/O
parameter is reloaded.
Replace a battery in
case of defective battery.
After I/O, parameter is
reloaded, check the
storage condition, and if
any fault is found,
replace the CPU
module.
STOP ERR : On Reset
converting
to RUN
mode.
25 Abnormal basic
parameter
Restart after basic
parameter is
reloaded.Replace a
battery in case of
defective battery.
After basic parameter is
STOP ERR : On Reset
Converting
to RUN
mode.
- 56 -
Chapter 4 - Troubleshooting

Honeywell ML200 Series Specifications

General

Brand	Honeywell
Model	ML200 Series
Category	Controller
Language	English