22 www.honeywell.com
Installing the MPA2 Panels
Installation
• OSDP readers address is default (factory) set to '00'. No extra setting
needs to be done when using one reader (Entry) and one door
configuration.
In case of two reader and one door configuration, make sure the Exit
reader (Reader B) is address '01'.
(For OSDP reader addressing settings, see reader
Instruction/Installation Manuals = Manufacturer dependent).
Figure 4: Wiring of Single Reader to the Controller Board (Door 1)
* For color-code, see info-card on the controller card assembly.
To Next Page
Loading...
