Installing the MPA2 Panels
Panel Components and Descriptions
MPA2 Access Control Unit Installation Guide, Document 800-25395 - B 3
frequency energy and, if not installed and used in accordance with the
installation and user guides, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely
to cause harmful interference in which case the user will be required to
correct the interference at his own expense.
This Class A digital apparatus complies with Canadian ICES-003.
To obtain applicable EU compliance Declaration of Conformities for this
product,
please refer to our website,
http://www.security.honeywell.com/hsce/international/index.html.
For any additional information regarding the compliance of this product to
any
EU-specific requirements, please contact:
Honeywell Security & Communications
Honeywell Security - Quality Assurance Dept., Newhouse Industrial Estate
Motherwell
Lanarkshire ML1 5SB
Scotland
United Kingdom
Tel: +44(0) 1698 738200
Email: UK64Sales@Honeywell.com
2.0 Panel Components and Descriptions
Note: This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may
cause undesired operation.
The MPA2 panel consists of a web-browser-enabled controller, a
power-over-Ethernet (PoE) power supply, and a battery (MPA2 Standard
only).
The following figures show the MPA2 panel wiring and components.
To Next Page
Loading...
