Honeywell MPA2 - Ethernet Virtual Loop - Network Dedicated to Access Control

Installing the MPA2 Panels
System Configuration
MPA2 Access Control Unit Installation Guide, Document 800-25395 - B 51
4.6 Ethernet Virtual Loop - Network Dedicated to Access Control
Figure 17: Ethernet Virtual Loop - Network Dedicated to Access Control
Note: 1. Router must provide DHCP service.
2. T
he Router has not been evaluated by UL.
EG
EG
EG EG
MPA2
Primary
MPA2
Panel
(Secondary)
NetAXS-123
Panel
(Secondary)
NetAXS-123
Panel
(Secondary)
MPA2
Panel
(Secondary)
ROUTER
To NETWORK
CAT 7 S/FTP
Ethernet Connection with EVL Loop on Dedicated Network
Terminal
DIP Switch Settings:
SW3: ON
SW9: ON
SW1 &10: ON : OSDP
SW1 &10: OFF: Wiegand
SW2: 4-8: OFF
DIP Switch Settings:
SW3: OFF
SW9: ON
SW1 &10: ON: OSDP
SW1 &10: OFF: Wiegand
SW2: 4-8: OFF
DIP Switch Settings:
S1-S5: Panel Address
S6: OFF
S7: OFF
S8-S9: ON: 485 Termination ON