Honeywell MPA2 - RS-485 Connections with Secondary Panels

Installing the MPA2 Panels
System Configuration
MPA2 Access Control Unit Installation Guide, Document 800-25395 - B 47
Note: You should ground each MPA2 Standard (Metal) Enclosure panel
individually with an Earth Ground.
4.2 USB Connection
Figure 13: MPA2 USB Connection
Note: The USB connection is intended to be used for system maintenance
and troubleshooting.
Note: You should ground each MPA2 Standard (Metal) Enclosure panel
individually with an Earth Ground.
USB
DIP Switch Settings
SW5-9: Panel Address
SW3: ON: Primary
SW4: OFF: Follow User-Configured IP
S1 7-8: ON: 485 Termination ON
DIP Switch Settings
S1-S5: Panel Address
S6: OFF
S7: OFF
S8-S9: OFF: 485 Termination OFF
DIP Switch Settings
SW5-9: Panel Address
SW3: OFF
SW4: OFF
S1 7-8: ON: 485 Termination ON
Terminal
USB A Male or Micro B Male (16 ft)
EGEG
NetAXS-123
Panel
EG
MPA2
Panel
MPA2
Panel
RS485