MX9 with Label
If the MX9 has a Bluetooth address bar code label attached, follow these steps:
1. Scan the Bluetooth address bar code label, attached to the MX9, with the Bluetooth mobile scanner.
2. If this is the first time the Bluetooth scanner has scanned the MX9 Bluetooth label, the devices are paired. See section
titled “Bluetooth Beep and LED Indications”. If the devices do not pair successfully, go to the next step.
3. Open the LXEZ Pairing panel (Start > Settings > System > Bluetooth).
4. Tap Discover. Locate the Bluetooth scanner in the Discovery panel.
5. Double-tap the stylus on the Bluetooth scanner. The right-mouse-click menu appears.
6. Select Pair as Scanner to pair the MX9 with the Bluetooth mobile scanner.
The devices are paired. The Bluetooth bar code reader responds with a series of beeps and an LED flashes.
Note: After scanning the MX9 Bluetooth label, if there is no beep and no LED flash from the Bluetooth device, the devices
are currently paired.
4-90
To Next Page
Loading...
