Honeywell MX9 - Installing a User Certificate

When the private key is exported, you must enter the
password, confirm the password and click Next. Be
sure to remember the password as it is needed when
installing the certificate.
Supply the file name for the certificate. Use the
Browse button to select the folder where you wish to
store the certificate. The certificate is saved with a
.PFX extension.
Click Finish. and OK to close the Successful Export message.
Locate the User Certificate in the specified location. Copy to the MX9. Install the user certificate.
Installing a User Certificate
After generating and exporting the user certificate, copy it from the PC to the MX9. Copy the certificate to a location on the
MX9, such as a storage card or the \System folder.
Locate the certificate file (it has a .PFX extension) and tap on it. You are prompted for the password that was assigned when
the certificate was exported.
Enter the password and tap Done. A message is displayed that the certificate installation was successful.
You can view any installed user certificates by selecting Start >Settings > System and tapping the Certificates icon.
Installed user certificates are displayed on the Personal tab.
9-56