Honeywell MX9 - Profile Parameters

Profile Parameters
Parameter Default Explanation
Edit Profile Default
A string of 1 to 32 alphanumeric characters, establishes the name of the
Profile.
Options are Default or ThirdPartyConfig.
SSID Blank
A string of up to 32 alphanumeric characters. Establishes the Service Set
Identifier (SSID) of the WLAN to which the client connects.
Client Name Blank
A string of up to 16 characters. The client name is assigned to the network
card and the device using the network card. The client name may be passed
to networking wireless devices, e.g., Access Points.
Power Save Fast
Power save mode is On.
Options are: Constantly Awake Mode (CAM) power save off, Maximum
(power saving mode) and Fast (power saving mode).
Tx Power Maximum
Maximum setting regulates Tx power to the Max power setting for the
current regulatory domain.
Options are: Maximum, 50mW, 30mW, 20mW, 10mW, 5mW, or 1mW.
Bit Rate Auto
Setting the rate to Auto will allow the Access Point to automatically
negotiate the bit rate with the client device.
Options are: Auto, 1 Mbit, 2, 5.5, 6, 9, 11, 12, 18, 24, 36, 48 or 54 Mbit.
Auth Type Open
802.11 authentication type used when associating with the Access Point.
Options are: Open, LEAP, or Shared key.
EAP Type None
Extensible Authentication Protocol (EAP) type used for 802.1x
authentication to the Access Point.
Options are: None, LEAP, EAP-FAST, PEAP-MSCHAP, PEAP-GTC, or
EAP-TLS.
Note: EAP Type chosen determines whether the Credentials button is
active and also determines the available entries in the Credentials
pop-up window.
Encryption None
Type of encryption to be used to protect transmitted data. Available options
may vary by SCU version.
Options are: None, WEP(or Manual WEP), WEPEAP(or Auto WEP),
WPA PSK, WPA TKIP, WPA CCKM, WPA2 PSK, WPA2 AES, or WPA2
CCKM.
CKIP is not supported in the MX9.
Note: The Encryption type chosen determines if the WEP Keys / PSK
Keys button is active and also determines the available entries in
the WEP or PSK pop-up window.
9-12