Application Configuration
Settings > System > Administration icon
The default Administrator Hotkey sequence is Shift+Ctrl+A.
Administrator mode allows access to all features on the device. When the hotkey is pressed to switch into Administrator mode,
a password prompt is displayed (if a password has been configured). A password must be entered within 30 seconds (and
within three tries) or the password prompt is removed and the device remains in end-user mode with the focus returned to the
locked application. Without entry of a valid password, the switch into Administrator mode will not occur.
The password prompt is displayed if a password has been configured. When the valid password is entered, the Administration
panel is displayed. When a valid password is not entered within 30 seconds, the user is returned to the System Panel.
If a password has not been configured, the Administrator panel is displayed.
Important: Before setting up multiple instances of the same application, make sure the targeted software application
will allow two instances to run at the same time.
4-53
To Next Page
Loading...
Need help?
General