Batteries
The MX9 is designed to work with a replaceable 2400 mAh Lithium-Ion (Li-Ion) battery pack from Honeywell. Under normal
conditions it should last approximately eight hours before requiring a recharge.
MX9 low temperature 2100 mAh Lithium-Ion (Li-Ion) batteries (designed for freezer environments and with a blue label) have an
average use time of 4 hours before requiring a recharge.
During very heavy scanning or wireless transmitter use, the operating time of the battery may be less.
HazLoc versions of the MX9 require a screwdriver to remove the plate covering the battery release mechanism.
Note: New main battery packs must be charged prior to use. This process takes up to four hours in an MX9 Battery Charger
and six hours when the MX9 is connected to external power.
Checking Battery Status
Tap the Start > Settings > System > Battery. Battery voltage level, status and power remaining is displayed.
Main Battery Pack
The main battery pack has a rugged plastic enclosure that is designed to withstand the ordinary rigors of an industrial
environment. Exercise care when transporting the battery pack making sure it does not come in contact with excessive heat or
any power source other than the MX9 Multi-Charger or the MX9 unit.
When the main battery pack is properly installed in the unit it provides up to eight hours of operation depending upon use and
accessories installed. The battery pack is resistant to impact damage and falls of up to four feet to a concrete surface. Under
normal conditions it should last approximately eight hours before requiring a recharge. The more you use the scanner or the
wireless transmitter, the shorter the time required between battery recharges.
When the MX9 is docked in a powered cradle, the battery in the MX9 is recharged through the cradle connector in the
docking bay. An extra Li-Ion battery pack can be recharged in a powered desktop cradle. The battery is fully recharged in a
powered cradle in less than 4 hours. The MX9 can be Off, in use or in Suspend Mode while the battery is recharging.
Note: When the main battery and internal battery are fully depleted, the MX9 turns off. The operating system reverts to the
last saved registry settings when a fully powered battery is inserted and the MX9 is turned on.
3-2
To Next Page
Loading...
