Car Power Adapter
The MX9 Car Power Adapter is a self-contained unit. The cable has one and a half feet of coiled cord and one and a half feet of
straight cord. The coiled portion is on the end of the adapter. An LED on the adapter illuminates when the car power adapter is
receiving vehicle input power.
The cigarette lighter adapter contains a power supply which converts the vehicle’s nominal 12V to 15V, a voltage suitable to
power the MX9 and charge the MX9 battery.
One end consists of a plug compatible with a standard vehicle cigarette lighter adapter (CLA). The Car Power Adapter has a
standard size CLA plug that uses center positive (+12V) and sleeve ground. A replaceable fuse is provided on the input side.
The other end of the three foot cable connects to the MX9 36-pin I/O port. It has a security latch for stability when connected to
the Car Power Adapter cable.
Replace CLA Fuse
Equipment needed: 5A fuse of the same size and amperage.
Remove the Cigarette Lighter Adapter (CLA) from the cigarette lighter outlet on the vehicle.
1. Disconnect the cable from the MX9.
2. Unscrew the tip of the CLA adapter end.
3. Replace the blown fuse with a fuse of the same rating and size.
4. Screw the tip back on to the CLA adapter end, replacing any previously removed parts in the order in which they were
removed.
Note: Upon reassembling the cigarette lighter adapter with the new fuse, and plugging it into the cigarette lighter port on the
vehicle -- if the LED on the CLA does not illuminate green, there may be a problem with the vehicle power source.
Locking the MX9
The MX9 can be locked manually by tapping Device unlocked on the Today screen. Care should be taken to not accidentally
tap this area of the Today screen.
Lock can be removed from the Today screen menu by selecting Start > Settings > Today > Items tab.
The MX9 can also be configured to Lock automatically after a defined period of inactivity. This setting is accessed on the Start
> Settings > Lock > Password tab. By default, this option is Disabled.
When the MX9 is locked, the Today screen displays Device locked by default. Tap Unlock at the lower part of the screen:
l If there is no password or PIN set, tap Unlock on the next screen to unlock the MX9. The MX9 is returned to normal
operation.
l If there is a password or PIN set, enter the password/PIN and tap Unlock. If several unsuccessful attempts are made,
the MX9 may be configured to display a password hint.
The password and hint are configured by selecting Start > Settings > Lock > Password and Hint tabs.
1-10
To Next Page
Loading...
